Wilibox wbd-111 - (Teltonika RUT-1xx base board)

OpenWRT

Flash firmware

Unfortunately sysupgrade is not yet implemented, you should go back to wikigear stock firmware then flash the new image

Build OpenWRT

  • download the latest trunk revision (you must use trunk because there are not a stable branch with gemini support):
svn co svn://svn.openwrt.org/openwrt/trunk/
  • add all available packages (download then “install”):
./scripts/feeds update -a
./scripts/feeds install -a
  • prepare your image (remember to select everything you need):
make menuconfig

Select as Target system: Cortina CS351x (StormSemi SL351x)

  • prepare your kernel (this step is uncommon, but it's indispensable for wbd-111):
make kernel_menuconfig

In this step you should include the right usb drivers:

**Device Drivers --->**
**USB support --->**
Mark as "built in" (*) **Support for Host-side USB**
Mark as "built in" (*) **EHCI HCD (USB 2.0) support**
esc-esc esc-esc... save!

To check if you have selected the correct driver after flashing image

dmesg | grep -i ehci-fotg2xx

should return

ehci-fotg2xx ehci-fotg2xx.0: Found Faraday OTG 2XX controller (base = 0x68000000)
ehci-fotg2xx ehci-fotg2xx.0: FOTG2XX EHCI Host Controller
ehci-fotg2xx ehci-fotg2xx.0: new USB bus registered, assigned bus number 1
ehci-fotg2xx ehci-fotg2xx.0: irq 10, io mem 0x68000000
ehci-fotg2xx ehci-fotg2xx.0: USB 0.0 started, EHCI 1.00, overcurrent ignored
ehci-fotg2xx ehci-fotg2xx.0: role detected: Host, 
ehci-fotg2xx ehci-fotg2xx.0: A-Device
ehci-fotg2xx ehci-fotg2xx.0: role detected: Host, 
ehci-fotg2xx ehci-fotg2xx.0: A-Device
usb 1-1: new high speed USB device using ehci-fotg2xx and address 2
  • make the image (where 2 is the number of your processor's core):
make -j 2

Teltonika RUT-104

Enable hso (3g modem) support

  • Select hso module in make menuconfig:
**Kernel modules  --->**
**USB Support  --->**
Mark as "built in" (*) **kmod-usb-net**
Mark as "built in" (*) **kmod-usb-net-hso**
Mark as "built in" (*) **kmod-usb-serial**
Mark as "built in" (*) **kmod-usb-serial-option**
esc-esc esc-esc... save!
  • Select PCCARD Bus support in make kernel_menuconfig:
**Bus support  --->**
Mark as "built in" (*) **PCI support**
Mark as "built in" (*) **PCCard (PCMCIA/CardBus) support  --->**
**PCCard (PCMCIA/CardBus) support  --->**
Mark as "built in" (*) **32-bit CardBus support**
esc-esc esc-esc... save!

Add built-in hso comgt support

  • Download and apply the patch to openwrt sources attached in this ticket.
Navigation
Print/export
QR Code
QR Code Wilibox wbd-111 - (Teltonika RUT-1xx base board) (generated for current page)