Differences

This shows you the differences between two versions of the page.

--- hardware:routerstationpro [2011/02/03 17:35] – Michele Porelli
+++ hardware:routerstationpro [2012/01/31 10:32] (current) – Michele Porelli
@@ Line 1: / Line 1: @@
 ====== RouterStation Pro ======
-===== Build OpenWRT =====
+===== DebWRT =====
+==== Build image ====
+  * svn checkout https://svn.debwrt.net/debwrt/trunk debwrt
+  * cd debwrt
+  * make menuconfig
+  * Target system is: Atheros AR71xx/AR7240/AR913x
+  * Subtarget is: Generic
+  * Target Profile is: Ubiquiti RouterStation Pro
+  * (if you are using usb drive instead of sd card) Enter in "Kernel Configuration" and edit the device in "Default kernel command line" from sda1 to sdb1
+  * (optional) make openwrt/menuconfig
+  * (optional) make openwrt/kernel_menuconfig
+  * make
+==== Prepare external rootfs (SD card or USB disk) ====
+  * Partition the USB Disk/Stick/Compact? Flash Card/SD Card:
+<code>/dev/sdb1 - DEBWRT_ROOT - Linux - ext3 - Rest of available size
+/dev/sdb2 - DEBWRT_SWAP - Linux Swap - 128MB</code>
+  * Create filesystems
+<code>mkfs.ext3 -L DEBWRT_ROOT /dev/sdb1
+tune2fs -c 0 -i 0 /dev/sdb1
+mkswap /dev/sdb2</code>
+==== Copy rootfs on your SD card or USB disk ====
+  * (if you have not automount) mkdir -p /media/DEBWRT_ROOT ; mount /dev/sdb1 /media/DEBWRT_ROOT
+  * make debian/rootfs/install (Be careful! An rm -Rf on /media/DEBWRT_ROOT is done first!)
+==== Flash firmware (kernel) ====
+  * Follow [[hardware:routerstationpro#Flash firmware|Router Station Pro OpenWRT flash instruction]] using bin/ar71xx-*-*-default/debwrt-firmware-ar71xx-generic-ubnt-rspro-squashfs-factory.bin
+==== Kernel upgrade ====
+Using "make openwrt/kernel_menuconfig" you can tune your kernel configuration, after your customization you can compile running "make" (NOTE: if you don't have an older enviroment you must follow the instruction to [[hardware:routerstationpro#Build image|build a DebWRT image]])\\
+To use the newer kernel you must unpack bin/ar71xx-*-*-default/debwrt-modules-ar71xx-generic_UBNTRSPRO-*-*.tar.gz in /media/DEBWRT_ROOT/ (assuming that you have mounted DebWRT rootfs on /media/DEBWRT_ROOT/) and follow the instruction to [[hardware:routerstationpro#Flash firmware (kernel)|flash DebWRT kernel]]
+===== OpenWRT =====
+==== Build image ====
   * svn co [[svn://svn.openwrt.org/openwrt/trunk/]]
   * cd trunk
@@ Line 11: / Line 40: @@
   * make
-===== Flash firmware =====
+==== Flash firmware ====
   * Connect your computer to the WAN port
   * Configure your network like this: 192.168.1.1/255.255.255.0 (anything but 192.168.1.20)
@@ Line 18: / Line 47: @@
   * You should be able to ping 192.168.1.20 now
   * Send the firmware image with tftp in binary mode:
-  * $ tftp 192.168.1.20
+<code>$ tftp 192.168.1.20
-  * tftp> binary
+tftp> binary
-  * tftp> put openwrt-...-factory.bin
+tftp> put openwrt-...-factory.bin</code>
+==== Re-enable LAN ports ====
+  * Install swconfig then:
+<code>swconfig dev eth1 set reset 1
+swconfig dev eth1 set enable_vlan 1
+swconfig dev eth1 vlan 0 set ports '0 1 2 3 4'
+swconfig dev eth1 set apply 1</code>
+==== Install wireless cards ====
+  * [[https://forum.openwrt.org/viewtopic.php?id=24682|How-To]]
 ===== Links =====
   * [[http://www.ubnt.com/rspro|Ubiquiti official page]]
   * [[http://www.ubnt.com/wiki/RouterStation_Pro|Ubiquiti wiki page]]
 ===== Operating system =====
   * [[software:openwrt|OpenWRT]] [[http://wiki.openwrt.org/toh/ubiquiti/routerstation.pro|page]]